★ ★ ★ ★ ★
"I have always had excellent service from Hartman Bros. They go above and beyond! Thank you, Ked S."
— Tina Fourman
(Google Review)
★ ★ ★ ★ ★
"I have used Hartman Brothers for many years. I have never had a problem. Top notch folks!"
— John Wiesemann
(Google Review)
★ ★ ★ ★ ★
"Great service ontime for my appt Gentleman was very friendly. He was very informative on what's going on with my unit. And I was happy with my experience with the company"
— Kendra Wetzel
(Google Review)
★ ★ ★ ★ ★
"Ked did a good job on both the furnace inspection and the Aprilaire humidifier installation. Knowledgeable and courteous."
— Bob
(Google Review)
★ ★ ★ ★ ★
"We could not be happier with our service, estimate for a new system and most of all offering to but coolant in the system to give us AC until new system is installed."
— Lanna Benjamin
(Google Review)
★ ★ ★ ★ ★
"Brian was very personable, explained everything he did and even wore booties so my carpet stayed clean! Hartman family & staff have always been wonderful Thank you!"
— Joy Panagiotou
(Google Review)
★ ★ ★ ★ ★
"I've had Hartman's install new Bryant H/Vac systems in 2 houses now and I've been pleased with the outcome at both houses. They are local, on time and reasonably priced. I've had a couple minor problems and Hartman Bros treated me fairly and took care of the issues. You don't buy 2 complete H/Vac systems from someone you don't trust or has treated you unfairly."
— Daniel Scheele
(Google Review)
★ ★ ★ ★ ★
"Very friendly and quick service, even on short notice. We will be able to sleep comfortably tonight with our fixed air conditioner! Thank you, Hartman Brothers!"
— Brittany Grote
(Facebook Review)
Heat ducts in a house are usually installed in the floor or the ceiling. But which one is preferable? Both locations have positives and negatives, depending on a number of variables.
Note: No matter where you place the ducts, fundamental facts of duct design always apply: The size of ductwork must be properly calculated to accommodate the required airflow volume and duct spans should be routed with as few sharp bends as possible.
